Y J Yang, I D Hope, M Ader, R N Bergman
J Clin Invest.
1989;
84(5):1620–1628
doi:10.1172/JCI114339
This article Copyright © 1989, The American Society for Clinical Investigation
Abstract
|
Full text
|
PDF
T
his study examined the relationship between transcapillary insulin transport and insulin action in vivo. During euglycemic clamps (n = 7) in normal conscious dogs we simultaneously measured plasma and thoracic duct lymph insulin and glucose utilization (Rd). Clamps consisted of an activation phase with constant insulin infusion (0.6 mU/kg per min) and a deactivation phase. [14C]Inulin was infused as a passively transported control substance. While [14C]inulin reached an equilibrium between plasma and lymph, steady-state (ss) plasma insulin was higher than lymph (P less than 0.05) and the ratio of 3:2 was maintained during basal, activation, and deactivation phases: 18 +/- 2 vs. 12 +/- 1, 51 +/- 2 vs. 32 +/- 1, and 18 +/- 3 vs. 13 +/- 1 microU/ml. In addition, it took longer for lymph insulin to reach ss than plasma insulin during activation and deactivation: 11 +/- 2 vs. 31 +/- 5 and 8 +/- 2 vs. 32 +/- 6 min (P less than 0.02). Rd increased from 2.6 +/- 0.1 to a ss of 6.6 +/- 0.4 mg/kg per min within 50 +/- 8 min. There was a remarkable similarity in the dynamics of insulin in lymph and Rd: the time to reach ss for Rd was not different from lymph insulin (P greater than 0.1), and the relative increases of the two measurements were similar, 164 +/- 45% and 189 +/- 29% (P greater than 0.05). While there was only a modest correlation (r = 0.78, P less than 0.01) between Rd and plasma insulin, the dynamic changes of lymph insulin and Rd showed a strong correlation (r = 0.95, P less than 0.01). The intimate relationship between lymph insulin and Rd suggests that the transcapillary insulin transport is primarily responsible for the delay in Rd. Thus, transcapillary transport may be rate limiting for insulin action, and if altered, it could be an important component of insulin resistance in obesity and diabetes mellitus.
This file is in Adobe Acrobat (PDF) format.
If you have not installed and configured the Adobe Acrobat Reader on your system.
Having trouble reading a PDF?
PDFs are designed to be printed out and read, but if you prefer to read them online, you may find it easier if you increase the view size to 125%.
Having trouble saving a PDF?
Many versions of the free Acrobat Reader do not
allow Save. You must instead save the PDF from the JCI Online page you downloaded it from. PC users:
Right-click on the Download link and choose the option that says something like "Save Link As...".
Mac users should hold the mouse button down on the link to get these same options.
Having trouble printing a PDF?
- Try printing one page at a time or to a newer printer.
- Try saving the file to disk before printing rather than opening it "on the fly." This requires that you
configure your browser to "Save" rather than "Launch Application" for the file type "application/pdf", and can
usually be done in the "Helper Applications" options.
- Make sure you are using the latest version of Adobe's Acrobat Reader.