P J Simpson, R F Todd, J C Fantone, J K Mickelson, J D Griffin, B R Lucchesi
J Clin Invest.
1988;
81(2):624–629
doi:10.1172/JCI113364
This article Copyright © 1988, The American Society for Clinical Investigation
Abstract
|
Full text
|
PDF
A
monoclonal antibody (904) that binds to a leukocyte cell adhesion-promoting glycoprotein, (Mo1; CD11b/CD18) was administered (1 mg/kg, iv.) to open chest anesthetized dogs 45 min after the induction of regional myocardial ischemia. Ischemia was produced by occluding the left circumflex coronary artery (LCX) for 90 min and then reperfusing for 6 h. There was no difference between control and antibody treated groups with respect to arterial blood pressure, heart rate, or LCX blood flow. Administration of antibody produced no observable effect on circulating neutrophil counts, suggesting that antibody-bound neutrophils were not cleared from the circulation. The mean size of myocardial infarct expressed as percentage of the area at risk of infarction that resulted was reduced by 46% with anti-Mo1 treatment (25.8 +/- 4.7%, n = 8) compared to control (47.6 +/- 5.7%, n = 8; P less than 0.01). The area at risk of infarction was similar between groups. Circulating (serum) antibody excess was confirmed in all 8 anti-Mo1 treated dogs by immunofluorescence analysis. Analysis of ST segment elevation on the electrocardiogram as an indicator of the severity of ischemia suggests that the anti-Mo1 reduces infarct size independent of the severity of ischemia. An additional group of dogs (n = 5) was tested with a control monoclonal antibody of the same subtype (murine IgG1) and was found to produce no significant reduction in myocardial infarct size. Accumulation of neutrophils within the myocardium was significantly attenuated with 904 treatment when analyzed by histological methods. These data demonstrate that administration of anti-Mo1 monoclonal antibody after the induction of regional myocardial ischemia results in reduced myocardial reperfusion injury as measured by ultimate infarct size.
This file is in Adobe Acrobat (PDF) format.
If you have not installed and configured the Adobe Acrobat Reader on your system.
Having trouble reading a PDF?
PDFs are designed to be printed out and read, but if you prefer to read them online, you may find it easier if you increase the view size to 125%.
Having trouble saving a PDF?
Many versions of the free Acrobat Reader do not
allow Save. You must instead save the PDF from the JCI Online page you downloaded it from. PC users:
Right-click on the Download link and choose the option that says something like "Save Link As...".
Mac users should hold the mouse button down on the link to get these same options.
Having trouble printing a PDF?
- Try printing one page at a time or to a newer printer.
- Try saving the file to disk before printing rather than opening it "on the fly." This requires that you
configure your browser to "Save" rather than "Launch Application" for the file type "application/pdf", and can
usually be done in the "Helper Applications" options.
- Make sure you are using the latest version of Adobe's Acrobat Reader.