A S Rocha, J B Magaldi, J P Kokko
J Clin Invest.
1977;
59(5):975–983
doi:10.1172/JCI108720
This article Copyright © 1977, The American Society for Clinical Investigation
Abstract
|
Full text
|
PDF
C
alcium and phosphate transport was examined in rabbit thin descending, thin ascending, and thick ascending limbs of Henle by in vitro perfusion of isolated tubular segments. Permeability coefficients for these segments with 45Ca and 32PO4 were determined for both lumen-to-bath and bath-to-lumen directions. Both the thin descending and thin ascending limbs were found to be relatively impermeable to both 45Ca and 32PO4. In neither segment were we able to show evidence for net transport of calcium or phosphate. In contrast, the thick ascending limb of Henle showed a decrease in calcium lumen-to-bath concentration from 0.97 +/- 0.02 to 0.88 +/- 0.02 when perfused at 4.8 nl min-1. 45Ca lumen-to-bath and bath-to-lumen fluxes were 19.96 +/- 1.05 and 9.89 +/- 0.02 peq-min-1-cm-1, respectively, and the potential difference was +3.8 +/- 0.3 mV (lumen positive). The observed calcium flux ratio was significantly higher than that predicted by Ussing's equation. When ouabain was added to the bath the potential difference fell to +1.1 +/- 0.3 mV, whereas the calcium efflux was only slightly diminished (29.5 +/- 5.3-23.7 +/- 5.1 peq-cm-1-min-1). Ouabain had no effect on the influx of Ca across the thick ascending limb of Henle. There was no net transport of phosphate across the thick ascending limb. Phosphate permeability was exceedingly low bidirectionally across the thick ascending limb. Our findings indicate: (a) all segments of Henle's loop are relatively impermeable to calcium and phosphate; (b) net transport of phosphate seems to be absent in Henle's loop; (c) net calcium reabsorption, which cannot be explained by passive mechanisms, occurs in the thick ascending limb.
This file is in Adobe Acrobat (PDF) format.
If you have not installed and configured the Adobe Acrobat Reader on your system.
Having trouble reading a PDF?
PDFs are designed to be printed out and read, but if you prefer to read them online, you may find it easier if you increase the view size to 125%.
Having trouble saving a PDF?
Many versions of the free Acrobat Reader do not
allow Save. You must instead save the PDF from the JCI Online page you downloaded it from. PC users:
Right-click on the Download link and choose the option that says something like "Save Link As...".
Mac users should hold the mouse button down on the link to get these same options.
Having trouble printing a PDF?
- Try printing one page at a time or to a newer printer.
- Try saving the file to disk before printing rather than opening it "on the fly." This requires that you
configure your browser to "Save" rather than "Launch Application" for the file type "application/pdf", and can
usually be done in the "Helper Applications" options.
- Make sure you are using the latest version of Adobe's Acrobat Reader.